ISOMAT TILES ADHESIVE AK-10
ISOMAT AK10 is a non-slip, cement-based tile adhesive for floors and walls. Provideshigh initial and final adhesive strength, as well as moisture resistance.Certified according to EN 12004 and classified as type C1 T adhesive. CE marked.Fields of applicationISOMAT AK 10 is suitable for fixing ceramic tiles on walls or floors, on surfaces made ofconcrete, brickwork, plaster, etc., indoors or outdoors.Technical dataForm: cementitious mortarColors: grey, whiteWater demand: 6.75 l/25 kg bagApplication temperature: from +5°C to +35°CApplication thickness: up to 10 mmPot life: at least 6 hOpen time: at least 20 minMinor adjustmentsopen time: at least 30 minSlip: ≤ 0.5 mmGrouting on walls: after 3-8 hGrouting on floors: after 24 hAdhesive strength after: 28 days: ≥ 1.10 N/mm2 heating in +70ºC: ≥ 0.50 N/mm2 immersion in water: ≥ 0.65 N/mm2 25 freeze-thaw cycles: ≥ 0.50 N/mm2Service temperature: from -15°C to +60°CAll measurements were conducted accordingto EN 12004Directions for use1. SubstrateThe surface to be overlaid must be clean, freeof dust, grease, paint, loose material, etc.Dampening of the substrate before applicationis recommended.2. ApplicationISOMAT AK 10 is gradually added to waterunder continuous stirring, until a uniform pasteis formed. A low speed mixer is recommendedfor mixing.The mixture should be left for about 5 minutesto settle and should be stirred slightly again.The tile adhesive should be spread and“combed” on the substrate using a notchedtrowel, in order to be uniformly applied on thewhole surface. The tiles should be pressurefixed to the desired position.The applied mixture must be covered with tileswithin 20 minutes in order to avoid “skin”formation, i.e. before the adhesive film startssetting.ElastificationFor tiling on unstable substrates subject tovibration or expansion-contraction, such asgypsum boards, chipboards, heated floors,terraces, balconies, etc. it is necessary to add5-10 kg of ADIFLEX-B to 25 kg of ISOMAT AK10, plus a quantity of water depending on thedesired workability, so that the tile adhesivebecomes more flexible.Consumption 1.5-4.0 kg/m2, depending on the trowel notch size and the nature of the substrate.