Language

Mr Bricolage Logo

Shopping Cart 0
€0.00

PARALIMNITIKO CEMENTILIOUS ADHESIVE ALFAKOL 2" 25KG GRAY

In stock
SKU
70208-00097
€8.55

PARALIMNITIKO CEMENTILIOUS ADHESIVE ALFAKOL 2" 25Kg GRAY

Specifications: EN 12004 C1TE

Description: Cementitious adhesive, with extended open time and no vertical slip.

Range of Application: Suitable for all ceramic and porcelain tiles for indoor use, on floor and walls. Also ideal for building YTONG blocks.

Product Identity
Appearance: cement-based powder
Color: Grey
Storage: 9 months in the original packaging, in a dry place
Particle size: 0-0.8mm
Application Data

Mixing Ratio: 25kg in 8L water
Pot life: 4h /mix every 1h, at 23oC & 50% RH
Open time: 30 min at 23 oC & 50% RH
Consuption: 2-5 kg/m2 depending on use and surface
Application temperature: +5 ºC - +35 ºC
Grouting: 24 h * * The time for grouting or for final use may vary depending on weather conditions, application thickness and the porosity of the substrate.
Adhesion Strength

≥ 0.5 Ν/mm2 according 12004

0.5 Ν/mm2 30 min open time
0.9 Ν/mm2 after 28 days
0.5 Ν/mm2 after water immersion
0.6 Ν/mm2 after heat ageing
0.7 Ν/mm2 after freeze/thaw cycles
Slip 0.5 mm
Temperature: -30ºC - +90ºC

Application

With the flat side of the trowel apply the adhesive to the substrate, pressing firmly to work into surface. Comb on additional adhesive with the notched side. Use the proper sized notched trowel to insure full bedding of the tile.

Spread as much adhesive as can be covered with tiles in 25-30 minutes. Place tiles into wet, sticky adhesive and beat in using a beating block and rubber mallet to imbed tiles and adjust level. If mortar is skinned over (not sticky), remove and replace with fresh mortar.

Substrates Preparation

All surfaces must be flat, structurally sound, free from dust, oil, grease and any other loose or contaminating materials.
To avoid immediate absorption of mix water by the substrate and for better adhesion saturate the surface to provide a saturated surface dry condition.
Preparing the mix- Application

Pour the material to a bucket of clean water mixing constantly with a low speed (400 rpm) electric mixer until a creamy consistency is achieved. Allow mixture settle for 5 minutes and remix prior the application. Attention! Additional water will make your mixture sloppy and may cause negative results on final strength

More Information
SKU 70208-00097
Color GRAY
Size 25Kg
Write Your Own Review
You're reviewing:PARALIMNITIKO CEMENTILIOUS ADHESIVE ALFAKOL 2" 25KG GRAY
Your Rating