Dry, Ready mix plaster with NO LIME for interior and exterior use.It conforms to European Standards ΕΝ998-1 & ΕΝ998-2 specifications.AdvantagesReady for applicationReplace traditional plastersStable standardized propertiesExcellent workabilityHigh Adherence and resistanceProduct Identity Appearance: Grey cement-based powder Packaging: 25 kg bags Storage: 8 months in the original packaging and in a dry place Particle size: 0-2.5 mm Application Data Mixing Ratio: 25kg in 6-8L water Pot life: 1 hour at 23ºC and 50% RH Thickness: 25-30mm/coat Consumption: - Plastering: 8-10 kg/m² depending on use and surface. - Brick Laying: 6-7 kg/ m² for 10cm masonry 20 kg/ m² for 20cm masonry Application temperature: +5 ºC - +35 ºCPlastering Allow 3-4 weeks after brick laying before plastering. Apply the 2nd hand at least one day after the 1st hand application. Apply the plaster on the prepared surface by spraying it or manually with a plastering trowel at a thickness between 10 and 30 mm in one layer. If more thickness is required, the application should be done in two layers. The 1st layer should be roughened then cured. Protect the newly applied plaster from sunshine and wind. The new plaster has to be cured with water for at least three days by spraying 3 to 4 times daily. Brick or block laying Bricks or blocks must be free of dust, at a temperature of +15 ºC -+25 ºC. PITTAKIS CEM is similar in application to conventional mortars. Joints between bricks should not exceed 10mm. Substrates Preparation The substrate must be solid, free of dust, loose parts and oils. To avoid immediate absorption of mix water by the substrate and for better adhesion saturate the surface to provide a saturated surface dry condition. Preparing the mix Pour the material into clean water and mix (mix in a concrete machine for big quantities or with a low speed electric mixer for small quantities) until a homogeneous lump free mix is obtained. Allow mixture settle for 5 minutes prior the application. Attention! Additional water will make your mixture sloppy and may cause negative results on final strength. Use the mixture when is still fresh. Do not leave the mix unmixed for a long time. Do not mix with water or latex additive when the mixture starts to set in the bucket. In such case the mix should be dropped.