Language

Mr Bricolage Logo

Shopping Cart 0
€0.00

PARALIMNITKO CEMENT BASED ACRYLIC TILE ADHESIVE ALFACOL 15* 25KG GRAY

In stock
SKU
70208-00108
€25.50

PARALIMNITKO CEMENT BASED ACRYLIC TILE ADHESIVE ALFACOL 15* 25Kg GRAY

Specifications: EN 12004 C2TE-S2

Description: High performance cement-based acrylic tile adhesive,with extended open time and no vertical slip. Exhibits high elasticity, excellent adhesion on all substrates, resistance to constant moisture, to frost and intense substrate movements.

Applications: Interior and exterior floor and wall bonding of all types and sizes of ceramic tiles, natural stone, marble, granite, porcelain ceramic, on cementitious renders, cementitious screeds and concrete.

Product Identity

Appearance: cement-based powder
Colour: Grey, White
Storage: 9 months in the original packaging, in a dry place
Particle size: 0-0.8mm
Application Data

Mixing Ratio: 25kg in 8L water
Pot life: 4h /mix every 1h, at 23ºC & 50% RH
Open time: 30 min at 23ºC & 50% RH
Consumption: 2-5 kg/m2 depending on use and surface
Application temperature: +5 ºC - +35 ºC Grouting: 24 h * * The time for grouting or for final use may vary depending on weather conditions, application thickness and the porosity of the substrate.
Adhesion Strength

≥ 1 Ν/mm2 according ΕΝ 12004

1 Ν/mm2 30 min open time
3.1 Ν/mm2 after 28 days
2.1 Ν/mm2 after water immersion
2.7 Ν/mm2 after heat ageing
2.5 Ν/mm2 after freeze/thaw cycles
Slip 0.2 mm
Deformability: 5.8mm
Temperature when in use: -30ºC-+90ºC

Application

With the flat side of the trowel apply the adhesive to the substrate, pressing firmly to work into surface. Comb on additional adhesive with the notched side. Use the proper sized notched trowel to insure full bedding of the tile.

The open time of ALFAKOL 15* is 30 minutes. Install the tiles within this period, in order to avoid skin formation. Place tiles into wet, sticky adhesive and beat in using a beating block and rubber mallet to imbed tiles and adjust level. If mortar is skinned over (not sticky), remove and replace with fresh mortar.

Unfavourable climatic conditions (high temperature, low humidity, wind, etc) can reduce this time to just a few minutes.

Substrates Preparation

Substrates must be mechanically sound, free of loose particles, grease, oil or other materials that reduce the adhesion. Dampening of the substrate before application is recommended.
The substrate must be stable without cracks and have already completed the curing period of hygrometric shrinkage. Uneven sections must be corrected with suitable smoothing and finishing product.

Preparing the mix

Gradually pour the material to a bucket of clean water mixing constantly with a low speed (400 rpm) electric mixer until a creamy consistency is achieved. Allow mixture settle for 5 minutes and remix prior the application. Attention! Additional water will make your mixture sloppy and may cause negative results on final strength.

More Information
SKU 70208-00108
Color GRAY
Size 25Kg
Write Your Own Review
You're reviewing:PARALIMNITKO CEMENT BASED ACRYLIC TILE ADHESIVE ALFACOL 15* 25KG GRAY
Your Rating