RUSTOLEUM COMBICOLOR HAMMERTONE ANTI-RUST PRIMER AND TOPCOAT 750ml LIGHT GREY
Anti-rust primer and topcoat in one, based on alkyd resins for direct application onto rust. Long lifetime Maximum elasticity Low odour Excellent anti-corrosion protectionExcellent one-coat coverResistant to knocksCoverage:10.5m²/L Drying Time:2 hoursTime Between Coats:8-16 hoursUse:INTERIOR & EXTERIORApplication Method:ROLLER, BRUSH, SPRAYThinner:THINNER 7302 (COMBICOLOR)RECOMMENDED USESCombiColor Hammertone 7300 can be applied directly on bare, manually derusted or withCombiPrimer Anti-Corrosion 3369/3380 primed steel.CombiColor Hammertone 7300 is intended for brush and roller application and can also beapplied by air spray.On properly primed or previously coated surfaces CombiColor Hammertone 7300 offerscorrosion protection in a light industrial environment.For metal structures in a more aggressive industrial environment, application of an additionalCombiPrimer Anti-Corrosion 3369/3380 is recommended or a second coat ofCombiColor Hammertone 7300 can be applied. CoverageTheoretical: 8.0 - 8.5 m²/l, depending on colour.Practical: Practical coverage depends on many factors such as porosity androughness of the substrate and material losses during application.SURFACE PREPARATIONRemove oil, grease and all other contamination by alkaline or high pressure (steam) cleaningin combination with appropriate detergents.Remove rust scale, loose mill scale, loose rust and loose coatings by scraping and wirebrushing to St3 (ISO 8501-1: 1988), light blast cleaning or sanding, followed by priming withthe recommended CombiPrimer Anti-Corrosion 3369/3380.Sand previous coatings in good condition to provide a key for adhesion and checkcompatibility. The surface must be clean and dry during application.Galvanised, Zinc and Aluminium surfaces have to be primed first with CombiPrimer Tack Coat3302. DIRECTION FOR USETo ensure homogeneity, coating materials should be thoroughly stirred prior to use.APPLICATION & THINNINGBrush: Up to 10 vol. % with 7301.Use natural bristles, long hair flat brushes for optimal hammertoneappearance.Roller: Up to 10 vol. % with 7301.Use short nap poly-amide (Perlon 6 - 12 mm) rollers.Air-atomised spray: 10-25 vol.% Rust-Oleum Thinner 7302.Gravity cup and pressure cup.Tip size: 1.0 - 1.5 mm. Atomising pressure 2 - 4 bar.Cleanup: Use Rust-Oleum Thinner 7301 or mineral spirits.APPLICATION CONDITIONSTemperature of air, substrate and coating material between 10 and 35°C, relative humiditybelow 85%. The substrate temperature must be at least 3°C above dew point.REMARKSBrushes, rollers and cleaning solvents should only be used for hammertone application.SAFETYConsult Safety Data Sheet and Safety Information printed on the can.SHELLIFE / STORAGE CONDITIONS5 years from date of production in unopened cans, if stored in dry, well ventilated areas, not indirect sunlight at temperatures between 5° and 35°C.