RUSTOLEUM ANTI-SLIP ADDITIVE 700GR

Anti-slip quartz sand for use with two-component floor paints.

Fully slip-resistant finish
Easy application
Good adhesion

DESCRIPTION
RUST-OLEUM® Hard Hat Aerosols Anti-Slip 2400 are based on a fast drying acrylic modified
short oil alkyd. The coloured products are based on lead- and chromate free pigments and
contain a special anti-slip additive.

RECOMMENDED USES
RUST-OLEUM Anti-Slip 2400 should be applied on metal, concrete, ceramic and wood surfaces or properly prepared painted substrates. Steel should be primed with 2169 or 2182.
RUST-OLEUM Anti-Slip 2400 are intended for small maintenance jobs or for touch-up.
RUST-OLEUM Anti-Slip 2400 should be used interior/exterior in light industrial exposures
where anti slip characteristics are required.

TECHNICAL DATA
Appearance: Satin
Colour: See colour card
Propellant: Butane/propane
Recommended film thickness: 25 µm dry, equals averagely 100 µm wet
VOC-content: 524 – 538 g/l
Drying times 20°C/50% r.v.
To touch: 20 minutes
To handle: 60 minutes
To recoat: After 1 hour with itself
Full hardness 7 days
Heat resistance: 100°C (dry heat), above 65°C discoloration may occur

Coverage
Theoretical: 2.5 m² per spray can at 25 µm dry
Practical: Practical coverage depends on many factors such as porosity and roughness of
the substrate and material losses during application.

SURFACE PREPARATION
Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means.
Sand intact coatings to provide a proper key for adhesion. The surface must be clean and dry
during application.

DIRECTION FOR USE
Remove cover cap. Shake vigorously for at least one minute after the rattle of mixing ball is
heard. Shake frequently during use. Hold the can approx. 25 cm from surface. Use back and
forth motion keeping can parallel with surface. Ensure that can is in motion when spray button
is pressed to avoid runs and sags. Apply several thin layers at a few minutes interval to
achieve adequate coating thickness. After use turn can upside down and press spray button
for 2 – 3 seconds to clean valve.

REMARKS
Not for use in wet areas such as bathrooms and on substrates, which are regularly in contact
with, water.

APPLICATION CONDITIONS
For good results the relative humidity shall be below 85% and the temperature of the can and
substrate above 10°C.